Home > Floor Repair & Installation Products >

Mannington MLG33 Low Gloss Seam Sealer

Mannington MLG33 Seam Sealer

Free Shipping on all orders
Our Price: $32.99



Mannington's MLG33 low gloss vinyl floor seam sealer kit is designed for Mannington Assurance II, Mannington Insight Plus, Mannington Realities, Mannington Primus and any vinyl flooring with low-gloss urethane-based wearlayer. A properly sealed seam will be as strong as the surface of the floor covering, and will remain intact for the life of the floor. Mannington's versatile sealing tip (VST-96) is included in this Mannington MLG33 seam sealing kit.

  • Easy To Use Vinyl Flooring Seam Sealer
  • This Kit Includes Everything Needed To Properly Chemically Weld/Seal Your Vinyl Flooring Seams
  • Two- Part Seam Sealer Designed For Low-Gloss Urethane-Based Wearlayers
  • Creates a Seam As Strong As The Surface of The Floor Covering
  • One Kit of MLG-33 Will Seal Approximately 70 Lineal Feet of Seams

  • DIRECTIONS FOR USE: Prior to sealing, be certain all seams are clean, dry and free of adhesive contamination. Part B, which contains the de-glossing agent, must be shaken vigorously before blending with Part A. Empty entire contents of Parts A and B into the supplied applicator bottle. After securing the VST Tip to the applicator bottle, gently shake the bottle to mix the ingredients. After mixing, the bottle should stand until all trapped air bubbles have dispersed, typically 15 minutes. Prior to use, check the flow of the sealer on a scrap piece of flooring. Use the forefinger of one hand on top of the flat portion of the tip to guide and ensure proper fin penetration. Use the other hand to control sealer flow. Hold the bottle at approximately a 45° angle. Lightly squeeze the bottle and apply a uniform bead of sealer approximately 1/8" wide centered on the seam cut. Note: Do not insert fin into the seam on Assurance II. For Assurance II use the applicator with the fin up. Be sure that the sealer is in contact with both sides of the flooring. Do not wipe the seam. Allow the sealed seam to dry before traffic can be allowed on the floor. Do not walk on or move heavy furniture directly over the sealer until it is fully dry. We recommend 24 hours. Mark the seam by placing a scrap piece of flooring along each side of the seam. Mannington MLG33 cannot be saved for reuse. Safely discard any unused sealer.

Average Rating: 5 of 5 Total Reviews: 1 Write a review »

  0 of 0 people found the following review helpful:
Speedy delivery! April 18, 2019
Reviewer: from STOUGHTON, WI United States  
I needed seam sealer while working on some problems with existing flooring. Timing was critical as I wanted to complete the flooring work before starting another project. Got the sealer in 2 days and completed that project and actually order more sealer so I could similar work. Timing and product was perfect!

Was this review helpful to you?